Can you fix a clicking external hard drive




















If your drive still keeps clicking on the computer then try to join it to the other computer. The above tips can exclude all your connection issues which may exist. In case, the clicking noise exists then continue to try the other fixes in detail.

This method is only applicable when a hard drive clicking noise issue caused by overheating or high temperature. In order to freeze or cool down your hard drive, you need to follow the below easy steps:.

When your external drive is creating a clicking sound, there must be some logical errors. Therefore, to repair the errors, you need to execute the Check Disk utility.

Step 2: Under a properties Window, choose the Tools tab. Step 3: Make a tap on Check button found under the Error-checking. Step 5: After finishing the fixing process, check if you can access your hard drive or not. Contact support team of a hard drive manufacturer for help. Take a clicking drive to the local repair center. Yes, of course, it is possible to recover data from hard drive clicking noise by using the powerful hard drive data recovery tool mentioned here.

There are many reasons due to which your hard drive could make a clicking noise. Opening the lid of a hard drive safely would require a clean room, and you will only open a hard drive when in fact you know the heads are damaged, or to check the platters when there is no other explanation for lack of access to the service area.

TIP: If the clicking is continual , or causes the drive to spin down , it is going to require temporary repair. In order to recover the data, the drive will have to be restored to working condition similar to before the failure. Recovering data from a drive in this condition will require advanced hard drive repair utilities, experience, and knowledge only professional data recovery companies like SERT possess.

Tip: Running a clicking drive for any time without knowing why, and being able to fix it, can cause a bad situation to become worse, and more expensive to fix. Repairing a clicking hard drive is going to require, first and foremost, an accurate hard drive diagnostic to determine what failure is causing the arm to click. This is the most important step in getting your data off a clicking hard drive.

Depending on what caused the clicking, your data may be in danger without following proper data recovery procedures. These are the major causes of the dreaded clicking drive sounds we recover data from on a daily basis. Freezer Trick: Do not listen to othe r inexperienced individuals or YouTube videos telling you to stick the drive in a freezer. Do not open the drive to inspect it either.

These are the worst two things anyone can do. I just had this issue. I thought I would use an express expansion card with 2 USB 3. Nope nope nope. Transfer froze up and the drive started clicking. I had same clicking problem and my icon wouldn't work right, all I did was buy new cord for my hard drive and it works like new again. So I guess it was the cord and the loose connection in the cord was the problem. Good luck on yours. If it's a drive in an enclosure, I'd start with seeing if you can remove it, and plug it directly into a computer or transplant it into a different external enclosure.

Much simpler and cheaper then most other methods of data recovery. While it's freezing, set everything up to quickly transfer your files off the drive if it does work. After a couple hours in the freezer, plug the drive in and see what it does. It may only work for a few minutes, for hours, or weeks. Pull your data off as fast as you can, if it stops again, re-freeze it and start where you left off.

I've frozen drives times to get everything off. I plugged my hard drive into a different USB port and it stopped clicking. My thesis, and 5 years of work are saved!! Taylor Arnicar tarnicar. This is going to sound very dumb, but I one time fixed a hard drive clicking problem where my disk was not reading properly, by turning my computer or in your case your external hard drive upside down.

This seemed to re-seat the needle head onto the disk, and my computer has worked great ever since. I originally laughed my friend off for giving me this absurd suggestion of turning my computer upside down so that it would turn on, but it worked, and I owed him a solid thank you. I fixed mine like that too. It was on a lenovo flex edge In my case, I opened up my laptop, took out the terabyte hard drive and flipped it upside down and put it back in.

Problem is totally fixed now and nor more annoying noise. I just fixed mine this way.. Show 3 more comments. Paul Jones. I just managed to get my clicking drive working by plugging the usb lead into one of the ports on the PC instead of a hub.

If you can find the same drive model you could swap the boards and give it a try.



0コメント

  • 1000 / 1000