Some reasons why you should not slide into first base: More often than not it is slower to slide rather than run through the bag. For more information, see section below. Take advantage of the fact that you can run through first base, which is not allowed for second or third base.
Avoid added injury risk. And some reasons why players want to slide into first: Sliding into first base can help the runner avoid a tag if the first baseman gets pulled off the bag. This can happen due to a high throw 1B jumping up , or on a ball thrown too far left or right pulling the 1B in that direction. This means the 1B must complete a tag or get back to the base for a force out. No one likes a clean uniform. In this situation, it is more likely that the fielders will be able to tag him out.
A batter-runner cannot be tagged out if he overruns or overslides on first base as long as he immediately returns to the base after the slide. However, this is not the case if the player is a base runner. If the batter-runner chooses to run towards second base , he can be tagged out.
Runners can get out from oversliding or overrunning at other bases from a force out or a tag out based on if there was force on the play. What happens if a base runner makes contact with the catcher when sliding into home plate? If the runner has his body on the ground prior to making contact with the catcher, it is a legal slide. On a slide, his legs and butt must be on the ground. For a dive, his body must make contact with the ground. Rob Costello is a journalism student at the George Washington University.
He is a past member of the Division 1 baseball team at GW, and has been writing about subjects surrounding the MLB and other major sports for the past five years. Costello is an expert on pitching mechanics, baseball-specific exercises and the culture of baseball in general. By: Robert Costello. Published: 05 December, More Articles. Each of the play diagrams shows the moment the runner hits first base. Let's keep it simple to start, showing two Gardner runs to first where he ran hard the entire time and ran through the base.
Back in April, Gardner attempted to bunt his way on against the Pirates, and while he wasn't successful, he did come up with his fastest home-to-first time of the season, 3. As you can see in the speed chart of the second half of the play, he ran hard the entire time, topping out just above 30 feet per second, and getting faster as he neared the base.
We'll show a similar play against the Mets from mid-August, except this one wasn't a bunt. This 3. But what about when Gardner doesn't run all 90 feet? In late August, Gardner attempted to beat out a grounder to the right side against Corey Kluber , and he was narrowly thrown out while sliding into first. Unlike the two full-run plays, there's now a noticable speed dip at the end of the play diagram, making it clear when the slide began. When he stopped running, he stopped maintaining his speed.
Instead, Gardner got slower. While his Sprint Speed of Sign up to receive our daily Morning Lineup to stay in the know about the latest trending topics around Major League Baseball.
We can see the same thing in a play from early August. Gardner grounded out to first baseman Jose Cabrera , who flipped to Jordan Zimmermann to narrowly get a sliding Gardner, with the ball arriving just.
Again, the speed decline is clear. Sept 22, Slide
0コメント